Setra Systems L series Specifications download pdf (Page 63)

Error Response

If the first register in this write command is not in the valid range of registers, the Power Patrol returns

an error message.

Report Slave ID

This command is used to read the description, the current status and other information specific to a

remote device. A normal response includes the data contents specific to the device.

Command Information

Command

Layout

Example

Command

Power Patrol address

Command number

Table D-8: Format for Modbus Command 11 (17 in decimal)

Example Command

Example Request

Field Name

Command

(Hex)

Response

Field Name

Response

(Hex)

Power Patrol address

Command number

CRC low order bits

Byte count

CRC high order bits

Slave ID

Run indicator status

Additional data

Table D-9: Format for Modbus Command 11 (17 in decimal)

Slave ID

The Power Patrol uses the following default format for the slave ID:

00hFFhSETRA Setra Systems Power Patrol 3, Serial Number, FW Rev Major Revision. Minor Revision, Scalar

Example:

00hFFhSETRA Setra Systems Power Patrol 3, PS3912001, FW Rev 1.0, Scalar 3

The 00h is used for version control and the FFh indicates the meter is active. The 00h and FFh are two

bytes in front of the string that are not displayed on the RTU.

NOTE: See VERIS H8035/H8036 Emulation for slave ID structure while in Veris emulation.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 89 90

No comments

Setra Systems L series Specifications Page 63