Setra Systems L series Specifications download pdf (Page 13)

FIELD INSTALLATION

Mounting a Power Patrol Meter

The Power Patrol

meter must be installed in an approved electrical panel or enclosure using proper

installation practices according to the local electrical codes.

 To mount the Power Patrol, use the two tabs provided at both ends of the case. Securely mount

the Power Patrol near a dedicated circuit disconnect breaker.

Figure I-1: Power Patrol mounting tabas

Wiring Connections on a Power Patrol Meter

High voltage MAY BE PRESENT. Risk of electric shock. Life threatening voltages may be present.

Qualified personnel only.

Haute tension peut être présente. Risque de choc électrique. Tensions dangereuses peuvent

être présentes. Personnel qualifié uniquement.

The Power Patrol meter has the following connections:

 Either a three-wire connector for the RS-485 BACnet/Modbus link and/or an Ethernet

connector.

 Four voltage connections. Voltage leads are customer supplied. The Power Patrol meter is self-

powered from L1 and L2.

WARNING! Remove the meter from all sources of voltage before mounting.

Mounting tab,

located on each

end of meter case

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 89 90

No comments

Setra Systems L series Specifications Page 13