Setra Systems 2000C Specifications download pdf (Page 4)

Section One

Installing Your Scale

SETUP

1. Locating your scale...

You should treat your scale as you would any piece of precision equip-

ment, locating it on a clean, dry surface; away from extremes of draft

and vibration.

2. Leveling your scale...

The bubble level is located underneath the loading pan. Adjust the

two front feet until the bubble is centered in the circle.

3. Installing the weighing pan...

Next, place the pan support over the shaft in the center of the unit.

Then, place the pan over the pan support.

4. Connecting your scale to an AC outlet...

To power up your scale, insert the appropriate end of the AC adaptor

into an electrical outlet. Now insert the connector end into the back of

the scale. The scale draws very little current from an outlet, and should

always remain plugged in. The display may be turned off by holding

down the ZERO key for five seconds. This keeps your scale always

ready to use with no “warm up” time.

5. Display test...

Each time your scale is plugged in, it automatically runs through a

display test lasting about thirty seconds, showing all possible seg-

ments which might be displayed, and then setting itself to zero. The

scale is then ready to be used. For best accuracy allow the scale to

warm up for 5 minutes prior to using or calibrating.

1 2 3 4 5 6 7 8 9 ... 31 32

No comments

Setra Systems 2000C Specifications Page 4